教育ICTに興味がある人の気になる記事

しばらく、ＰＶのファームウェアアップデートしませんね。
まぁ、特に問題もなく、快調に走れているのでいいのですが。

ＰＶのファームのアップデート内容、メモっておきます。


■Firmware 1.0.6-904
Fuel Mileage Trip Center ? allows you to correct Distance, Fuel Used, and MPG
channels to yield accurate MPG readings.
Auto Channel Setup for Log Tuner Sessions, along with “Visual VE Table”
with flying cursor and cell count (PIN 319245) .
Added new diagnostic test: J1850 Read Freeze Frame data
o If in the event the “Check Engine Light” illuminates, you can enter
PIN 924107 and select “Read Freeze Frame Data”. This will show
(on the device) the vehicle’s operating conditions and sensor values
present when the fault occurred. The freeze frame report is
contained within the “DiagnosticHistory.txt” file that’s able to be
extracted and read with WinPV.
Fixed bug where "C" Diagnostic Trouble Codes were being displayed as
"X" codes.
Only show the "Trips since last DTC" if there is a DTC

■WinPV Software 1.0.44.914
Added Smooth and Interpolate functions to WinPV
Added Undo function to WinPV
Added “Revert to Last Loaded” function to WinPV
Added a visual indication to identify parameters that don’t match when
using the compare feature. This offers a quick, easy way to identify where
the tune has changed.
o Yellow Flag = different
o Green Flag = doesn't exist in compare, but does exist in active file
(so you can't comare it to the compare).
o Red Flag = exists in compare, but does NOT exist in active file (so
you can't edit it)
Added “Exit PC Link Mode” function to WinPV. This will allow you to enter a
few menus, such as “Datalog” without the need to have the Power Vision attached
/ plugged into the bike. No more draining the battery to assign channels to gauges

■Tune / Configuration Database 0.0.9.4
Added support for ECM p/n 32534-11, 2011 Service ECM for “drive by
cable” J1850 bikes