Faroudjaのセットアップレベル
昨日、いきなり、常用機のmarantz DV-12S2が壊れてしまった・・・(T_T) ディスクが、出てこないのである。仕方ないので、修理に出したのだが、戻ってくるまでの間、PS3を使うことにした。 Blu-rayは、それなりに、綺麗だと思うんですが、DVDの画質は、見るべきものがないですね。(´`;) HDMI接続だと、480Pでしか出力できないし、色差接続でFaroudjaでアップスケールしてみてますが、 絵に切れはないし、色乗りも悪く、滑らかさに掛けます。そもそも、私が使っている、Faroudjaは、セットアップレベルが、7.5IREで固定なので、セットアップレベルを変えられないPS3では、真黒側の階調がなくなります(;_;) 以前、この件で、Faroudjaのサービスに以下のように直接問い合わせたことがあります。I:が私で、F:がFaroudjaです。 私の方は翻訳ソフトを参考にしながらの下手な英語であちこちおかしいとは思いますが、相手には意味は伝わってるようなので勘弁してくださいませI:I bought the unit from the United States recently.And, I want to change a black level of this unit to 0IRE for Japan.Please teach me the change method.F:The NRS unit does not have a 0 / 7.5 IRE selection that you are asking for.What you can go is to lower the brightness control to the correct level and then store that setting into a preset. I:I think that in the method of using brightness control, the signal on a black end side is lost.If the person chooses faroudja, this problem must be anxious.I have any questions.Is it sold in the dealer in Japan, and is black level set to 0IRE as for this product?If the answer of the question on the above-mentioned is yes, can my unit be set to 0IRE at the factory?For the time being,I will solve this problem by using dvd player that can select black level now.F:There are no firmware update for the NRS product lineand there were no different models for US or Japan markets.I would suggest that you correct the black level using your DVD player selection.The other suggestion is to use an AVIA test disk and using a Pulge test pattern to set the black level using the brightness control. 私の方はへたな英語ですが、書いてること解ります?要約すると、NRSにはセットアップレベルを変更する機能はないので、ブライトネスで調整してくれってことなんですが、 私にしてみれば、ブライトネスを使う方法だと、真黒側の情報が失われるので嫌なわけなんです。 それで、日本の代理店を通して販売されたNRSは、0IREにセットされているか、もし0IREになっているなら、私のNRSをFaroudjaの工場で0IREにセットしてほしいって頼んだんですが、日本向けの製品と米国向けの製品に違いはないそうなんですよね。 まぁ、私の場合は、個人輸入したものなので、文句を言える立場ではないですが、 確か当時、Faroudjaの代理店からは、黒レベルを変更できる機器でなければ、色差入力時に黒がつぶれますって、アナウンスはなかったと思います。ちょっと、企業としての良心に欠ける気がするんですが。(--;)DVP-1010以降は、セットアップレベルを変更出来ますので問題ありませんが、それ以前の機種をお考えの方はご注意くださいませ。 ただファームがないから出来ないってことなので逆説的に言えば、ファームで対応できる機種は、ファームアップでセットアップレベルを変更する機能が追加される可能性もありますね。