自宅サーバー構築メモ（その４） centos5.4にOpenIPMIをインストール
# yum install OpenIPMI
～省略～
Installed:
OpenIPMI.x86_64 0:2.0.16-5.el5_4.1
Dependency Installed:
OpenIPMI-libs.x86_64 0:2.0.16-5.el5_4.1
net-snmp-libs.x86_64 1:5.3.2.2-7.el5_4.2
Complete!
# yum install OpenIPMI-tools
～省略～
Installed:
OpenIPMI-tools.x86_64 0:2.0.16-5.el5_4.1
Complete!
# chkconfig --list ipmi
ipmi 0:off 1:off 2:off 3:off 4:off 5:off 6:off
# chkconfig ipmi on
# service ipmi start
Starting ipmi drivers: [ OK ]
# service ipmi status
ipmi_msghandler module loaded.
ipmi_si module loaded.
ipmi_devintf module loaded.
/dev/ipmi0 exists.
# ipmitool sdr
POST Error | Not Readable | ns
Memory ECC | Not Readable | ns
ACPI State | 0x01 | ok
PCI Reset | 0x00 | ok
CPU Fan | 2017.76 RPM | ok
Rear Fan | 2035.00 RPM | ok
CPU Diode | 32.50 degrees C | ok
Front Ambient | 20.50 degrees C | ok
System 12V | 11.93 Volts | ok
System 5V | 5.12 Volts | ok
System AUX 5V | 5.01 Volts | ok
System 3.3V | 3.40 Volts | ok
System AUX 3.3V | 3.33 Volts | ok
CPU Vcore | 1.02 Volts | ok
CPU 12V | 12.04 Volts | ok
HT 1.2V | 1.20 Volts | ok
Mem Vcore | 1.80 Volts | ok
MEM VTT | 0.89 Volts | ok
MCP55 1.5V | 1.51 Volts | ok
MCP55 1.4V | 1.40 Volts | ok
Therm-Trip | 0x01 | ok
CPU Prochot | 0x01 | ok
System Reset | 0x01 | ok
NMI | 0x01 | ok
PCI Error | Not Readable | ns
CPU Socket | 0x02 | ok
LO100 Present | 0x01 | ok
Watchdog | Not Readable | ns
# ipmitool chassis status
System Power : on
Power Overload : false
Power Interlock : inactive
Main Power Fault : false
Power Control Fault : false
Power Restore Policy : previous
Last Power Event :
Chassis Intrusion : inactive
Front-Panel Lockout : inactive
Drive Fault : false
Cooling/Fan Fault : false
Sleep Button Disable : allowed
Diag Button Disable : allowed
Reset Button Disable : allowed
Power Button Disable : allowed
Sleep Button Disabled: false
Diag Button Disabled : false
Reset Button Disabled: false
Power Button Disabled: false
